8
●
Before every operation, visually check the equipment for exterior mechanical damage(s) and for
proper function.
●
Immediately turn off and unplug any equipment that gives off smoke, sparks, strange noises, or
odors.
●
After the equipment has been used in an observation of a specimen that is accompanied with a
potential of infection, clean the parts coming in contact with the specimen to prevent infection.
●
In case the specimen is damaged by erroneous operation, promptly take the infection prevention
measures.
●
Power Supply Cord set (international) - (Detachable) Rated 10 A, 250 V. Plug type CEE 7A/II,
Connector type IEC 60320/C13, and Cord type H05W-F3G, min. 0.75 mm2,3-conductor
terminating in molded-on grounding type attachment plug. <HAR> marked on the cord. Maximum
4.0 m long.
●
Do not position the equipment so that it is difficult to operate the disconnecting device,
(disconnecting device: power cord, appliance inlet, etc.)
CAUTION
To avoid the risk of electric shock, this equipment must only be connected to a supply main with
protective earth.
The protection provided by the equipment may be impaired if the equipment is used in a manner not
specified by the manufacturer.
●
When moving the microscope, grasp rear handle and the base with more than two peoples as
shown below.
Summary of Contents for PA53MET
Page 13: ...13 6 NOMENCLATURE...
Page 14: ...14...
Page 15: ...15 Control box and control pad are provided PA53MET 3D PA53MET BD 3D only...
Page 17: ...17...
