Introduction
Thank you for your purchase of a Motic microscope. Motic microscopes are precision instruments, subjected
to meticulous examination in order to reach you in perfect condition. Their design combines easy
management and optimum functioning with minimum maintenance.
The information contained in this manual is likely to go beyond what the average user needs to know to use
the microscope, however, it is provided to answer any queries that may arise.
Your new microscope combines high performance features, with an excellent degree of optical resolution
and clarity of image. It incorporates a 84mm x 88mm stage with objectives located on a ball bearing
nosepiece; a precision focusing system; a disk diaphragm with six holes and a plano-concave mirror.
These instructions should be read carefully before operating the microscope. They will permit you to use
your new microscope to its fullest capabilities. Terminology used to describe components and controls can
be found in the diagram on page 2.
These instructions are based on the assembly and use of the SFC-3AF model with additional notes
applying specifically to other models in the series.
Unpacking
All components of the microscope have been carefully packed to make sure they reach you in perfect
condition. We recommend that you do not discard any packing containers in case you need to return the
microscope, store it for long periods of time; or should it become necessary to transport it to a technical
service for any repair or maintenance procedure.
The box should contain the following components, depending on the model:
•
SFC-3A: A microscope with a monocular vertical head with an eyepiece, coarse focusing system,
stage with diaphragm and three objectives. A dust cover is also provided.
•
SFC-3AF: A microscope with a monocular vertical head with an eyepiece, coarse and fine focusing
system, stage with diaphragm and three objectives. A dust cover is also provided.
•
SFC-3BFR: A microscope with a monocular inclined rotating head with an eyepiece, coarse and fine
focusing system, stage with diaphragm and three objectives. A dust cover is also provided.
Remove, and handle the microscope and all its components with extreme care.
Avoid touching the lenses of the optical elements and keep clear of contact with dust, water or other
contaminating agents, as they could stain or damage the lens surface and affect the quality of the
image.
A. Place the microscope in an upright position on a clean flat and stable surface.
B. Remove the rest of the components from the box.
-3-
