6
•
The location should be free from dust, moisture, chemical vapors and mechanical vibrations.
•
Do not situate the instrument in a warm and/or humid environment.
•
Locate the instrument where the operator’s line of vision is not directed towards a window, a lamp or a
well-lit bright wall. The quality of the viewed image from the microscope will deteriorate where there is
significant ambient light.
IV Assembling the microscope Input voltage
•
Automatic voltage selection works with electrical outlets worldwide. However, always use a power cord
that is rated for the voltage used in your area and that has been approved to meet local safety
standards. Using the wrong power cord could cause fire or equipment damage.
•
The use of an extension cord is discouraged and may damage the electrical components of the
microscope.
•
In order to prevent electric shock, always turn the power switch on the power supply off before
connecting the power cord.
1
Installing the lamp
•
In order to prevent electric shock always turn the power switch off and unplug the power cord before
replacing the lamp.
•
Loosen and remove the lamp housing cover clamp screw using a coin. Then remove the lamp house
cover.
•
When installing the lamp, do not touch the glass surface of the
lamp with bare fingers. Doing so
will cause fingerprints, grease, etc., to burn onto the lamp surface,
reducing the illumination provided by the lamp. If surface is contaminated, wipe it clean using lens
tissue.
•
Firmly insert the lamp into the socket pinholes until it reaches the limit, be careful not to tilt the
lamp when mounting.
•
Close the cover and fasten with it with lamp housing cover clamp screw.
2
Mounting the Condenser
Power Cord
Lamp Housing Cover
Clamp Screw
Power Switch
