Motion Concepts Lateral Hip Support, Installation Setup Manual

- 4 -

2.0   Installation & Adjustment

Lateral Hip Support Installation & Adjustment

With the client seated in the chair, determine (

approximate

) the most desirable fore & aft mounting location

for the Lateral Hip Support and select the nearest (existing) mounting holes the seat side frame. 

(

note:

the

mounting bracket for the Hip Support is typically installed around the center of the seat side frame;  Further
height and depth adjustments are available via the upright bar and the hip pad)

.  Please refer to 

Figure 2.0

for detailed adjustment options.

1. With the mounting position determined, use the hardware provided to install the mounting bracket onto
the seat side frame.  Refer to Step 

A.

in 

Figure 1.0

below .  

(

note:

the seat may need to be tilted to access

the underside of the seat side frame). 

2.  With the mounting bracket installed, slide the upright plate into the slot of the mounting bracket and
adjust the height of the plate to establish the final hip pad height.  Install the stop bar (see 

Figure 1.0

- Step

B.

below) onto upright plate at the mounting hole position that comes closest to the achieving the desired

overall height.  

(

note:

lower plate adjustments are available in 

5/8”

increments- refer to 

Figure 2.0

).

Note:

The following instructions show installation on the left-hand side of the chair; repeat all

steps indicated to complete the right side Hip Support installation.  Please read through the
entire instruction manual before proceeding with the installation.

Lateral Hip Support Installation

Figure 1.0

set-screw 

(for fixed support)

hand-wheel lock 

(for removable support upgrade)

C

B

A

Step A:

Secure the mounting bracket onto

seat frame using the hardware provided

Step B:

Adjust the upright plate to the

desired position (height) and fasten the
stop bar to the plate.

Step C:

Using the available height and depth

adjustments- install the hip pad onto the upright
plate using the hardware provided

mounting bracket

hip p

ad 

(8“ x 3-1/2”)

upright

plate

stop bar