6
6.1
6.2
Before programming a favorite position, the blind needs to be moved
from its top position to its bottom position twice. This is necessary to
save the favorite position. Do not stop the blind during this process.
Shortly press the program button on the smart switch. The blind will start stepping and
the LED on the smart switch will start blinking, indicating that program mode has been
activated.
Hold the
program
button until the blind stops stepping (approximately 5 seconds) to
de-activate or re-activate direct control.
When pressing the up or down button on the remote control the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be de-activated. Now, the blind only directly moves to its end
positons when the up or down button is held longer than two seconds.
De-activate
direct control
15
Summary of Contents for CM-34
