motobilt.com | 334-219-2333
5
MB1110 JT Gladiator Crusher Rear Bumper – Installation Instructions
Loosen the bolts holding the rock rail
mounting brackets. Do not remove the
bolts.
If your vehicle is NOT equipped with the
optional rear rock rocks, you will need the
MB1111 Gladiator Rear Corner Supports to
complete your installation.
Using a 16mm socket, remove the four (4)
flange nuts from behind frame mounting
plates.
With all fasteners removed & wiring
disconnected, remove the factory rear
bumper from the vehicle.
If your vehicle is equipped with optional
rear tow hooks, remove these tow hooks
now.
Using a cut off wheel, remove a small
portion of metal above the factory
receiver hitch (as shown removed). Apply
paint to cut edges of bare metal if desired.
14
17
15
16
18
Preparing for installation
19
