Page 28
M5 CONNECT - Using the Adjustable Distance Control
Fig 2
Fig 3
Fig 1
Using the Adjustable Distance Control
The M5 CONNECT features a basic, easy to use adjustable distance control which will allow you to
send your trolley ahead of you from 15 - 45 metres.
1. While stationary select the speed that you wish your trolley to set off at
2. Hold down the on/off button for 2 seconds, you will see the outer digits of the LED display rotate
once clockwise (fig. 1) and “1” will then flash on the display (fig. 2). There are three settings for the
distance, 1 = 15 metres, 2 = 30 metres and 3 = 45 metres
3. Turn the button clockwise to increase and anti-clockwise to decrease to your preferred distance
4. Press the on/off button to set the trolley in motion. While the trolley is powered using ADC,
the left hand indicating LED will flash
5. The trolley can be stopped manually by pressing the button again
In the unlikely event that your trolley fails to register distance while in ADC mode, the trolley will cut
power to the motor to prevent the trolley from travelling too far. The trolley screen will flash “E” to
indicate that this safety feature has been activated (fig. 3).
The trolley can be reset by pressing the on/off button once, thereby allowing you to continue to use
the trolley with ADC disabled until you are able to contact our technical support team.