Attaching the mount to your trolley
1. Start with your trolley folded.
2. Release CATCH 2 and unfold upper frame
section slightly so that the trolley can still
rest on the handle (fig.1) and secure catch.
3. Release CATCH 1 and unfold front wheel
fully until it locks into position (fig.2).
4. The larger section of the mount should
be placed on the top of the tubes going to
the front wheel housing (fig.3). The arrow
inside the mount should point towards
the front wheel.
5. The smaller section of the mount also
has an arrow that should point towards
the front wheel. Secure the two sections
together using the 6 screws provided (fig.4).
The mount should be attached as close
to the front wheel housing as possible
so that CATCH 1 can still be released.
Assembling the seat
The main section of the seat will
arrive in two sections.
1. Attach the padded seat top
to the twin tubed section.
2. Insert the nuts and bolts in
position and secure using
the allen key provided (fig.5)
Fitting the seat to the trolley
1. Insert the seat bar into the mount (fig.6).
2. The seat will slot onto the end of the bar (fig.7).
fig.1
fig.2
fig.3
fig.4
fig.6
fig.5
fig.7