Page 20
Pairing the Remote Control / Handset Lock function
Pairing the Remote Control
In the unlikely event that the remote is not responding or you have a new remote handset, it will need to
be paired to the trolley.
To pair the remote to the trolley:
1. Press and hold the stop button on the remote handset for 5 seconds (fig. 1a)
2. The LED on the handset will start flashing green (fig. 1b), at this point release the button and plug the
battery into the trolley
3. If the trolley is not powered on within 60 seconds, the handset will exit pairing mode
Handset Lock function
The remote handset can be locked by pressing the Lock button (fig. 2a), when this is pressed the LED
will either flash Green or Red (fig. 2b). Green indicates that the handset is unlocked and Red indicates
that it is locked.
When it is locked the +/-/< & > buttons will be disabled and a Red LED will flash when they are pressed,
the Stop button will still operate and show a Green LED when pressed.
If the handset is locked whilst the trolley is running in remote mode, the trolley will stop after 4 seconds as
the handset will stop sending a signal. If the trolley is in Manual mode it will continue to run but can still
be stopped using the stop button of the handset.
Pressing the Lock button again (fig. 2a) so the LED flashes Green (fig. 2b), will unlock the handset and all
buttons will be enabled.
Fig 1
Fig 2
A
A
B
B