WARNING!
Remove any jewellery (watch, ring, etc.). Be careful not to short-circuit the battery with any
metallic object (wrench, etc.).
WARNING!
To prevent irritation and burns, wear protective eyewear and clothing when you install the
power inverter or work with a car battery. Should battery acid come into contact with
skin or eyes, flush it with water and consult your physician.
CAUTION!
Power connections from a 12 V battery to the power inverter must be
POSITIVE (RED)
TO POSITIVE AND NEGATIVE (BLACK) TO NEGATIVE.
A reverse polarity connection (positive
to negative) will blow a fuse in the power inverter and may permanently damage the unit.
Damage caused by a reverse polarity connections is not covered by your warranty.
CAUTION!
Loose connectors result in an excessive voltage drop and may result in overheated wires and
melted insulation.
CAUTION!
Do not start the car engine during operation.
Connect
Follow the instructions in the section (See connecting the connector cables to the power
inverter) to connect the cable to the power inverter.
• Fasten the POSITIVE /+ (RED) CLAMP TO THE POSITIVE /+ BATTERY POST, and then fasten
the NEGATIVE /–(BLACK) CLAMP TO THE NEGATIVE/–BATTERY POST. Make a secure
connection.
• The power inverter is now ready for use.
CAUTION!
If you are going to disconnect the battery, switch the power inverter off first (See
switching on/off).
CAUTION!
Always disconnect the power cables from the car battery when you are not using the device.
Switching on/off
• Be sure to have your power inverter properly placed and connected according to the
wattage that is to be connected before attempting to turn the unit on.
• Switch the power source on in case it is turned off.
• Switch on the power inverter: Press and hold the on/off button (H) until the digital
display (F) turns on. The display shows the battery voltage, indicating that the
power inverter is operating normally and AC power is available at the power inverter.
• Plug in the device that you want to operate to either the AC power inverter or the
USB port.
CAUTION!
After plugging in the devices, turn them on ONE AT A TIME. This will ensure that the
power inverter does not have to deliver the surge currents required for all the loads at once.
20
model no. 011-1901-4 | contact us: 1-877-466-8191
21
OPERATION
OPERATION
