10
CONTROLS AND INDICATORS
Model no. 011-1975-8 l Questions? Contact us 1-888-942-6686
CONTROLS AND INDICATORS
A. Digital Display
During charging, the digital display will alternate between Volts (V), Amps (A) and Battery State of
Charge (%). It can also display Fault Codes if a charging error is detected.
Volts
—Actual charging voltage will be displayed. Charging voltage can reach up to 14.4 V— this
is normal and required to effectively charge a 12-volt battery.
Amps
—Actual charging amperage will be displayed. While you may select 2 A, 8 A or 15 A charge
modes, these are maximum currents and the battery charger will reduce actual current delivered to
the battery based on feedback from the battery and other factors.
Stage of Charge
—The approximate battery state of charge is displayed. A reading of "LO"
indicates that the battery is below 50% state of charge. Above 50%, the percentage will display in
10% increments between 60 to 90% capacity. Once the battery is fullly charged, the display will
read "100%".
NOTE: About 30 minutes after reaching full charge, the battery charger will enter a power-saving
mode and the digital display will turn off.
Fault Codes
—The charger will continuously monitor charge progress and collect feedback from the
battery during charging. In the event an abnormal condition is detected, charging will stop and a
fault code (e.g., "F01") may be displayed. (See "Troubleshooting/Fault Codes" for possible causes
and solutions.)
NOTE: A fault condition will also be indicated by the LED illuminating.
B. Charge Status Indicators
CHARGING LED—Indicates battery is charging.
CHARGED/MAINTAINING LED—Indicates charging is complete and the battery charger has entered
the Maintain stage. (See Understanding Charging Stages.)
LED—Indicates one of three possible error conditions:
A
B
C
888
888
