11A
11B
02
03
2
3
1
2º
1º
2º
1º
01.A
01
05
07
06
08
04
09
10
EN
EN
04. INSTALLATION
SAFE INSTALLATION
01.
Place the safe under a protective material (card). Lift the safe's cover and slide it
forward so it unhook from the safe, as shown above in
DETAIL (01.A).
Remove all the loose
components inside the safe as fixtures, receivers and carts.
03.
Slightly loosen the screws marked in
03.A
image and apply (s) stand (s) in the safe. Slide
the small profile with rubber on the inside of the cart closer to the safe, leaving the rubber
1mm safe (03).
02.
Apply the screws and washers that are in the accessory kit.
04.
Remove the grippers caps and place the plates that are in the kit (each gripper requires
two or three plates depending on the size of the leaf).
07.
Direct the glass holes with the existing
holes of the grippers. This operation must
be performed on the ground, on top of a
protective support (card).
08.
Apply the screw on the side where this is
embedded in the profile. Also apply the nut
on the other side and tighten the screw.
06.
Apply the nylon washers in the existing
holes of the glass.
05.
When using a standard gripper, slide the
gripper's cover to acess the holes.
04. INSTALLATION
SAFE INSTALLATION
10.
Place the caps so that the covers do not
slip and fall.
09.
Refit the gripper cover.
