19A
19B
1
2
4
3
FUNC
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
2
4
3
FUNC
EN
EN
1
2
4
3
FUNC
05. PROGRAMMING
SELETOR
05. PROGRAMMING
SELECTOR
Com os comandos do seletor, pode controlar o automatismo para realizar as seguintes ações:
1
2
4
5
3
1. Always Closed:
All radars and controllers are disabled. The lock is automatically triggered,
which causes the door to close.If you connect a fire alarm and put the door in
this function, the door will not open if it receives an alarm order.
2. Always Open:
All radars and controllers are disabled. The door stays open.
3. Partial Opening (Automatic Operation):
The radars are activated. The door opens only partially (65% of total course)
automatically. Whenever activated this function, the door does a new path
recognition.
4. Exit Only:
• The external radar is disabled and the lock is activated automatically. The con-
trollers and inner radar stay activated. Only opens for exiting people.
5. Total Opening (Automatic Operation):
All radars and controllers are activated. The door opens and closes automatically.
Change Password:
Change the selector's function in "Free Mode":
In "free" mode, you can select the desired function by pressing it for
5sec, without having to put the password.
In case of forgetting your password, follow the next steps:
Reset the Selector:
01
• Press and hold the
FUNC button for 10 sec.
The selector will beep
twice. First at 5 sec
and then at 10 sec.
01
• Unscrew the
screw cover (below the
switch) and remove
the rear panel.
03
• The selector beeps once confirming the reset's success. The password returns to 1234. Refit
the back cover and tighten the screw.
02
• Unscrew the
screw cover (below the
switch) and remove
the rear panel.
02
• Enter the code
(original - 1234).
03
• Press the FUNC
button to confirm.
05
• Press the FUNC
button to confirm.
07
• Press the FUNC
button to confirm
again. The new
password is now set.
04
• Enter a new code.
06
• Enter for a second
time the new code.
1
3
4
2
1
3
4
2
1
3
4
2
1
3
4
2
1
2
4
3
FUNC
• PROGRAMMING
You can use the selector in two modes: Code and Free. In "code" it is necessary to put a
combination of four numbers (original code is 1234) to change the operating function.
Press and hold the FUNC 1 key (LOCK) for 5 sec. The selector
will beep and the light changes from red (Code mode) to green,
indicating that it is in free mode. Repeat the procedure to switch to
code mode.
Change the selector's function in "Code Mode":
Changing from "Code Mode" to "Free Mode":
01
• Press and hold the
FUNC button for 5 sec.
The selector will beep
and the LED turns
green.
02
• Enter the code
(original - 1234).
03
• Press the FUNC
button to confirm.
04
• Choose one of the
functions described
above by pressing the
key corresponding to
the function.
