6A
2
3
5
4
1
1
2
3
4
5
30~100mm
30~100mm
350mm
EN
03. INSTALLATION
ASSEMBLY THE SHAFT
Leave an excess of 350mm at the spring vain through the support. Insert a protection ring
on the vain.
FIT MOTOR
Place the motor on the shaft of 3-10 cm left over from both sides.
See detail A.
MARK THE HOLES
Place the plate on the motor without tighten completely.
Touch the plate on the wall and make markings.
DRILL THE HOLES
Remove the motor's plate and make the drills to fixate the motor.
ATTACH MOTOR
Fix the plate on the wall and then fix it in the motor.
Put the protection ring on the vain, touch it to the motor and and tighten.
AUTOMATISM INSTALLATION
• The gearmotor must be installed in a protected area of shocks.
• The fixation surface should be solid.
• Should be used accessories with capacity to fixing the engine to surface.
• Install suitable tubes for the passage of electrical cables, to ensure the complete
protection against mechanical damage.
• The door structure must be resistant enough, with efficient hinges.
• There should be no friction between fixed parts and moving parts.
DETAIL A
