13A
13B
28
29
30
EN
EN
•
Clean the arm.
•
Lubricate pins
•
Check motor supports
• With a cloth soaked in lubricant spray, wipe any residue that accumulates on the operator’s
arm.
• Apply a small amount of spray lubricant on the arm and using a dry cloth remove the excess,
leaving a homogeneous layer of lubricant over the arm.
• Remove front and rear caps
• Place a small amount of lubricant on the holes that contains support pins.
• Install caps on the respective holders.
•Make sure that supports remain well fixed on the pillars and gate to ensure proper functioning of
the equipment.
These maintenance measures must be applied every year in order to insure proper
functioning of the automated system.
07. MAINTENANCE
07. MAINTENANCE
MAINTENANCE
MAINTENANCE
