6A
6B
EN
EN
04. INSTALLATION
BOOM SUPORT INSTALLATION
TOP COVER REMOVAL
04. INSTALLATION
When the position of the boom’s support is defined,
you can fix it to the ground.
Make two holes on the fixing ground, and place the
screws supplied.
Align the support holes with those same screws and
fasten the support using the nuts.
1 • Open the door using the key supplied to
unlock it and then pull it to the outside.
3 • The hooks that secure the top cover are also
rotated and release the cover.
Before starting the tuning of the springs is
necessary to remove the screw identified in the
illustration.
ADJUSTMENT • To adjust the springs, you must use a
wrench to fasten or release the springs nuts. If you
rotate them clockwise you are giving tension to the
springs causing the boom to rise up, and rotating
counterclockwise you are removing tension from
the springs causing the boom to descend.
4 • Pull the cover up to remove it.
2 • Rotate the rod (image above) to unlock the
cover.
TOP COVER REMOVAL
SPRING ADJUSTMENT
screw A
