13A
13B
12A
12B
EN
EN
04
• Appears the
function currently set.
If you want, change
the function to 00 or
01, using
↓↑.
04
• Appears the
function currently set.
If you want, change
the function to 00 or
01, using
↓↑.
07
• Appears the
function currently set.
If you want, change
the function to 00 or
01, using
↓↑.
PRESENT MAN
DISTANCE PROGRAMMING
06
• P1 appears.
To exit the
programming press
↓↑ simultaneously.
01
• Press MENU for
10 seconds.
02
• E0 appears.
Press MENU for 1
second.
09
• E1 appears.
To program E1,
continue in step 3
from E1 menu (page
13A). To exit the
programming press
↓↑ simultaneously.
03
• HP appears.
Press MENU for 1
second.
06
• PL appears.
Press MENU for 1
second.
05
•
Press MENU for 1
second to confirm the
defined time.
08
•
Press MENU for 1
second to confirm the
defined function.
04. PROGRAMMING "P"
05. PROGRAMMING "E"
distance PGM OFF
distance PGM ON
This menu allows you to enable or disable
the new transmitters programming without
access directly to the control board by using
a previously stored transmitter (memorize
transmitters page 5B).
Factory default (
00
)
Distance programming operation (PGM ON):
•
Press the keys indicated in the picture at the same time for 10
seconds and the flashing light will start to flash (the display shows
the 1st free position).
Whenever you memorize a transmitter, the control board will
leave the distance programming mode. If you want to program
more transmitters, you will need to repeat the process of pressing
simultaneously the transmitter buttons for 10 seconds for each new
transmitter.
03
• P9 appears.
Press MENU for 1
second.
05
• Press MENU to
save the defined
function.
01
• Press MENU for 3
seconds.
02
• P0 appears.
Press ↓ nine times.
Present man -
closing
02 (activates present man at the closing)
The present man is active only in
closing.
Present man
01 (activates p
resent man
)
The motor only works if you hold down
the pushbutton LS or LO.
00 (deactivates p
resent man
)
Whenever an order is sent to the LS
and LO the motor performs a complete
maneuver.
Push button mode
(Factory default
00
)
(Factory default
00
)
LS Button LO Button
01
ACTIVATED
Total
Opening
Total
Closing
00
DEACTIVATED
Pedestrian
maneuvers
Total
maneuvers
