7A
7B
6A
6B
EN
EN
This submenu performs a semi-automatic programming of the working time of the motor, set-
ting the slow speed areas manually.
To do this, you must press MENU at the moment you want to start the soft stop (slow speed),
both in the opening and closing phases.
If you do not press MENU at any time, an automatic programming will be performed without
any deceleration.
This programming can be done without limit switches, but it is mandatory to press MENU
whenever the door reaches the end of each course.
03
• AU appears.
Press MENU
for 1 second to
start automatic
programming.
01
• Press MENU for 3
seconds.
02
• P0 appears.
Press MENU for 1
second.
04
• When
programming is
complete, the display
returns to the initial
state (--).
AUTOMATIC PROGR. OF THE COURSE
04. PROGRAMMING "P"
03
• AU appears.
Press ↑ 1 time to
show MA.
01
• Press MENU for 3
seconds.
02
• P0 appears.
Press MENU for 1
second.
04
• When MA
appears, press MENU
for 1 second. The
motor will start a
slow closing of the
door.
05
• When it reach the closing limit
switch, it will open automatically.
06
• Press MENU when you want to
start the opening deceleration.
07
• When you reach
the limit switch, it will
automatically close.
08
• Press MENU when you
want to start the closing
deceleration.
SEMI-AUTOMATIC PROGR. OF THE COURSE
04. PROGRAMAR "P"
This menu allows automatic programming of the motor and deceleration.
During automatic programming, the motor will perform the following maneuvers:
1º
Slowly close the gate until it reaches the end of the closing course
2º
Slowly opens for aabout 10 seconds
3º
Slowly closes until it reaches the limit switch
4º
The gate opens at normal speed until it reaches the limit switch
5º
The gate closes at normal speed until it reaches the limit switch
Steps 2 and 3 are only made if P2-dF is set to a value equal to or greater than 1.
If P2-dF is set to 0 (zero), you will only do steps 1, 4, and 5.
