13A
13B
EN
EN
ERL ERRORS
06. COMPONENTS TEST
If the display shows the error
ERL1, 2, 3
it means that one of the input phases is missing or
that the motor connections are incorrect.
Check all connections and try again.
To remove errors from the display you just need to click on any button on the control panel
or in charge.
NOTES:
• This control board was developed only to work with Motorline motors, however if you
want to work with motors from other manufacturers make sure that this motor is in star
configuration and that it is a 400V motor that does not exceed 1500W.
INDICAÇÕES DO DISPLAY
05. FUNCTIONS
IN STOP POSITION, FULLY OPEN
IN STOP POSITION, MIDDLE POSITION
IN STOP POSITION, FULLY CLOSED
TOTAL OPENING BUTTON PRESSED
PEDESTRIAN OPENING BUTTON PRESSED
CONTROL BOARD RUNNING OPENING COURSE
CONTROL BOARD RUNNING CLOSING COURSE
END OF OPENING COURSE TIME
END OF CLOSING COURSE TIME
ALL TRASMITTERS DELETED
TRANSMITTER ADDED IN THE INDICATED POSITION
OBSTRUCTED PHOTOCELL
OBSTRUCTED PHOTOCELL 2
IN PAUSE TIME
IN PEDESTRIAN PAUSE TIME
EMERGENCY BUTTON PRESSED
NO LIMIT-SWITCHES INSTALL
PHASE 1 OR MOTOR FAILURE
PHASE 2 OR MOTOR FAILURE
PHASE 3 OR MOTOR FAILURE
