• Receiving the message during a group or broadcast call – radio allows receipt of the text message
during ongoing group call and broadcast call. The group/broadcast call is displayed with the
New
mail arrived
icon and tone for mail received played.
• Emergency Mode – you can receive SDS messages. To read the SDS messages the radio have to
leave the emergency mode. Sending the SDS messages in the emergency mode is prohibited.
When sending long, segmented text messages, a timer is activated. If not all segments of the message
are received before the timer expires, the whole sending process is considered as failed. The service
provider sets the value of the timer.
2.7.3
Immediate Text Messages
NOTE:
This is a Software Selling Feature.
The Immediate Text Messaging feature enables the radio to receive and display text messages
immediately. This feature is used for sending information of high importance from the console to
radios.
When the radio receives an immediate text message, the following occurs:
• The immediate text message is stored in the
Inbox
.
• The content of the immediate text message is displayed.
• The relevant audio tone is played.
• If the periodic alert feature is enabled, the periodic alerting is active until you press the
Soft
key.
NOTE:
If this feature is disabled, the immediate text messages are processed as normal text
messages.
When you reply or forward an immediate text message, the message is sent as a normal text
message.
When the radio receives more than one immediate text message, the latest received immediate text
message is displayed. All previous immediate text messages in the
Inbox
are not prompted.
2.7.4
Home Mode Display Text Message
Your radio is provided with a feature that allows your service provider to send special text messages
to the display. The message is limited to 24 characters. The message stays on the home screen until
a new home mode display message is received. Power cycle your radio to replace the Home Display
message to the predefined one.
2.7.5
Predefined Templates (ATS Entry Prompt)
This feature assists the radio in sending formatted messages with a predefined destination address
(MSISDN, SSI, or TSI) for computer applications.
You can select a predefined entry prompt which defines a message format to help with the construction
of a Short Data Service (SDS) message. The prompt definition is set in the codeplug. The definition
sets areas that are read-only, areas that can be edited, and the type of characters that can be entered
(numeric, alpha-numeric, or phone digits). Along with the message definition, the address to send the
message is provided.
When you send the message, it is sent using SDS Transport Layer with the PI that is provisioned in the
codeplug. A receipt report is requested.
MN003465A01-AF
Chapter 2 : Services and Features
19