Sarix Professional 4 Bullet Camera Installation Manual
C6726M | 11/22
16
Configuring the Camera
After the camera is installed, configure it using the instructions in the current version of the Pelco Sarix
Professional 4 Bullet Camera Operations Manual.
Connecting to Power and External Devices
If PoE is not available, the camera may be powered through the auxiliary power cable using either
12 VDC. The power consumption information is listed in the product specifications.
To power the camera, connect the two power wires to the auxiliary power wires. The auxiliary power wire
is distinguished by its thicker wire gauge and
AUX PWR
label. The connection can be made with either
polarity.
This product is intended to be supplied by a UL Listed Power Unit marked “Class 2” or “LPS” or
“Limited Power Source” with output rated 12 VDC, 13 W min. or Power over Ethernet (PoE),
rated 48 VDC, 13 W min.
To avoid damaging the camera, do NOT connect auxiliary power to the audio or I/O terminal
block, and do NOT install the Microphone accessory and an external audio input device
simultaneously.
Power supplies and external devices are connected to the camera through the power and I/O wires.
For the locations of the power and I/O connector blocks, see
The pinout for the I/O and power wires is shown in the diagram on the following page.
