Appendix A:
7.
Spread out the three wires, so that the
Blue
wire is on the right side, the
Brown
wire is on the left
hand side, and the
Green
wire is in the center.
8.
Attach the cable wires to the terminal plug in the following way:
Figure 9-21
Correct Position of the Cable Wires Attached to the Plug.
9.
Fold the plug back into a closed position and turn the plug to show the access screw. Tighten the
Access Screw
on the plug to lock the plug assembly in place.
Figure 9-22
Finished Plug
Access Screw
Insert the Green Wire into
the Ground lug and tighten.
Insert the Blue Wire into the
Neutral lug and tighten.
Insert the Green Wire into
the Ground lug and tighten.
9-19
Summary of Contents for 2.1
