17
Instal
lation and Set
u
p
Hardware Installation
When the base is connected and the PC MX240a software
is running, a green icon (
) appears in the taskbar status
area.
If the base is disconnected from your computer, a red icon
(
) appears in the taskbar status area. If neither icon
appears, launch the MX240a software.
Note: The handheld unit is portable and therefore is not
hardwired to the base unit or your computer.
Handheld Power-Up and Registration
To register the handheld unit to the base unit:
Action
1
Plug the USB connector at the end of the base
unit cable into an unused USB port on your
computer.
2
Place the base unit in any convenient location
away from your computer to prevent interference.
Action
1
Ensure the MX240a software is running on your
PC and the base is connected. To check this,
look for the green icon (
) in the taskbar status
area of your computer screen.
2
Press and hold
ª
to turn on the handheld unit.
The Welcome screen displays and the power on
alert sounds.
1041b80a.book Page 17 Friday, January 31, 2003 9:42 AM