Introduction
1
1
Introduction
The AP-650 Thin Access Point, a component of the Motorola Wireless Switch System, links wireless
802.11a/b/g/n devices to the switch, enabling growth of your wireless network with a cost-effective
alternative to standard access points. The AP-650 Thin Access Point provides two placement options:
wall and ceiling. Wall mount slots fit onto two screws provided. Arrows on the case guide placement
of the screws. For placement above a suspended ceiling, a safety wire tie point on the case provides
for a loop of safety wire. The light pipe fits through a hole in the ceiling tile to provide a view of the
unit’s status lights.
The AP-650 Thin Access Point receives all power and transfers data through the same CAT-5 or better
Ethernet cable. There is no additional power supply required. An 802.3af Ethernet switch or power
injector is required.
1.1 Document Conventions
The following graphical alerts are used in this document to indicate notable situations:
1.2 Warnings
•
Read all installation instructions and site survey reports, and verify correct equipment
installation before connecting the AP-650 Thin Access Point.
•
Remove jewelry and watches before installing this equipment.
•
Verify that the unit is grounded before connecting it to the power source.
•
Verify that any device connected to this unit is properly wired and grounded.
•
Verify there is adequate ventilation around the device, and that ambient temperatures meet
equipment operation specifications.
NOTE
Tips, hints, or special requirements that you should take note of.
CAUTION
Care is required. Disregarding a caution can result in data loss or
equipment malfunction.
WARNING!
Indicates a condition or procedure that could result in personal injury or
equipment damage.
!
