Installation Guide
15
6.
Install the RJ11 (keystone style) connector into the AP-6511E’s snap-in port.
7.
If using the optional second RJ-45 Ethernet port (utilizing a pass through keystone cable), ensure the
following steps are completed:
a. Bend the cable into a “U” shape so the mini pin connector and the RJ-45 keystone cable are in close
proximity to one another.
b. Install the mini pin connector into the pin socket on the back of the AP-6511E. The connector is keyed
and can only be installed one way. Ensure the mini pin connector is connected securely.
c. Remove the blank plug from the keystone hole by gently pushing it out from the back.
d. Orient the RJ-45 keystone connector so the flexible keystone tab is away from the mini pin connector.
Tip the keystone RJ-45 while installing in the keystone opening so the solid locking tabs engage, then
rotate the RJ-45 forward until the tab snaps securely.
8.
Install the RJ-45 double plug uplink jumper into the UP1/POE jack and connect it into the
RJ-45 Ethernet connector.
To PBX
RJ45 connector
Summary of Contents for AP-6511E
