8
AP-6511E Access Point
2
Hardware Installation
2.1 Installation Instructions
An AP-6511E Access Point mounts either on a wall, under a table or over a Telco Box. The AP-6511E is not plenum
rated.
The AP-6511E is mounted to a wall or Telco Box so the mounting plate is flush with the mounting surface.
The AP-6511E snaps on to the mounting plate without the use of tools or fastening hardware. Removal of the
AP-6511E from the mounting plate can be accomplished without the use of a tool. A mounting lock screw is
provided to help ensure a tamper resistant installation.
To prepare for the installation, perform the following:
1.
Verify the contents of the box includes the intended AP-6511E Access Point model and accessory
hardware.
2.
Review site survey and network analysis reports to determine the location and mounting position for the
AP-6511E Access Point.
3.
Connect a CAT-5 or better Ethernet cable to a PoE compatible device and run the cable to the installation
site. Ensure there is sufficient cable slack to perform the installation steps.
NOTE
The provided metal mounting plate is fastened to an existing standard
Telco in-wall box. The box is customer provided within the customer
building structure, and can be either plastic or metal in composition.
Screws and other mounting hardware are not include.
NOTE
Once installed onto the mounting plate, the assembly can resist a
minimum of 10 lbs of force before unit breakage or accidental
disassembly.
Summary of Contents for AP-6511E
