6
AP6522E Access Point
1
Introduction
The AP-6522E Access Point, a component of the Motorola Solutions wireless controller system, links wireless
802.11abgn devices to the controller, enabling the growth of your wireless network with a cost effective
alternative to standard Access Points. The AP-6522E Access Point provides multiple deployment options.
The AP-6522E Access Point receives all power and transfers data through the same CAT-5 or better Ethernet
cable. An 802.3af Ethernet switch or power supply (specifically rated for the AP-6522E) is required (Part No.
PWRS-14000-148R).
An AP-6522E model Access Point uses WiNG 5 software as its onboard operating system. The Access Point’s
unique WiNG 5 software enables the Access Point to function as either a Virtual Controller AP capable of
adopting and managing up to 24 additional AP-6522E Access Points, a Standalone Access Point or a Dependent
mode Access Point managed by its connected controller.
If new to Motorola Solutions Access Point technology, refer to the
WiNG Access Point System Reference Guide
to
familiarize yourself with Access Point technology and the feature set supported by the WiNG operating system.
The guide is available, at
https://portal.motorolasolutions.com/Support/US-EN/WNetworks
.
The AP-6522E Access Point is approved under MODEL: AP-0622.
This document is written for the qualified network device installer.
1.1 Document Conventions
The following graphical alerts are used in this document to indicate notable situations:
NOTE
Tips, hints, or special requirements that you should take note of.
CAUTION
Care is required. Disregarding a caution can result in data loss or
equipment malfunction.
WARNING!
Indicates a condition or procedure that could result in personal injury or
equipment damage.
!
