Installation Guide
27
10. Select an
Access Point Type
from the following options:
•
Virtual Controller AP
- When more than one access point is deployed, a single access point can
function as a Virtual Controller AP. Up to 24 access points can be connected to, and managed by, a
single Virtual Controller AP of the same AP6562 model.
•
Standalone AP -
Select this option to deploy this access point as an autonomous fat access point. A
Standalone AP isn't managed by a Virtual Controller AP, or adopted by a controller.
•
Adopted to Controller
- Select this option when deploying the access point as a controller managed
(Dependent mode) access point. Selecting this option closes the Initial AP Setup Wizard. An adopted
access point obtains its configuration from a profile stored on its managing controller. Any manual
configuration changes are overwritten by the controller upon reboot.
NOTE
If designating the access point as a Standalone AP, Motorola Solutions recommends
the access point’s UI be used exclusively to define its device configuration, and not
the CLI. The CLI provides the ability to define more than one profile and the UI does
not. Consequently, the two interfaces cannot be used collectively to manage profiles
without an administrator encountering problems.
Summary of Contents for AP6562
Page 1: ...AP6562 Access Point INSTALLATION GUIDE ...
Page 2: ...2 AP6562 Access Point ...
Page 58: ...58 AP6562 Access Point ...
Page 59: ...Installation Guide 59 ...