6.4.4
Restoring a Nuisance Channel
Procedure:
To restore the deleted nuisance channel, perform one of the following actions:
• Stop and restart a scan.
• Mode change to another channel and back to the original channel.
• Turn off the radio and then turn it on again.
6.5
Call Alert Paging
This feature allows your radio to work like a pager.
If other users are away from their radios or if they are unable to hear their radios, you can send them
an individual call alert page. You can also verify if a radio is active on the system.
Depending on how your radio is programmed, if there is no answer after the maximum ring time or
when you press the
PTT
button for an Enhanced Private Call, the radio automatically sends a call alert
page.
NOTICE:
This feature must be preprogrammed by a qualified radio technician.
6.5.1
Receiving a Call Alert Page
When and where to use:
When you receive a Call Alert page, you hear four repeating alert tones and
the LED blinks green. The call received icons blinks and the display shows
Page received
.
Procedure:
Press any button to clear the Call Alert page.
Making a Talkgroup Call on page 35
or
Making a Private Call (Trunking Only) on page 35
for more
information on returning the call.
6.5.2
Sending a Call Alert Page
When and where to use:
Do one of the following to send a call alert page:
NOTICE:
If the feature inactivity timer is enabled, your radio automatically exits the feature
when your radio is left idle long enough for the time to expire. You hear the Menu Inactive Exit
Tone upon feature exit.
Procedure:
• Sending a call alert page using the radio menu
Page
:
a.
or to
Page
.
b. Press the
Menu Select
button directly below
Page
.
c. Press the
Menu Select
button directly below
Cnts
to view the required ID,
or
to the
required ID.
MN003110A01-AJ
Chapter 6: Advanced Features
50
