Canopy
T1/E1
Multiplexer
June
2004
T1/E1
Multiplexer
Release
3.1
13 of 69
The recommended sequence of connection is:
1. Connect a PBX or TDM CPE to the T1/E1 port(s). (See
Figure 3
on Page
11
.)
2. Connect the Ethernet cable from the Canopy Backhaul Module to the jack
labeled Canopy. (See
Figure 3
on Page
11
.)
3. Connect the selected power adapter to the T1/E1 Multiplexer. (See
Figure 4
and
Figure 5
.)
4. Power the T1/E1 Multiplexer on. (See
Figure 4
.)
5. As required to configure the T1/E1 Multiplexer, connect a PDA or notebook
computer to the jack labeled CONTROL on the front panel of the T1/E1
Multiplexer. (See
Figure 7
.)
1.2.5
Front
Panel
The control port and indicator LEDs are located on the front panel of the unit.
Figure 7: Canopy T1/E1 Multiplexer front panel
Issue
1
Page