1-18
Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
Installing a Module
This section describes a recommended procedure for installing a board
module in a chassis.
Before you install your module, please read all cautions, warnings, and
instructions presented in this section and the guidelines explained in
Before You Install or Remove a Board
Use ESD
Wrist Strap
Handling modules and peripherals can result in static damage. Use a
grounded wrist strap, static-dissipating work surface, and antistatic
containers when handling and storing components.
!
Caution
Insert the board by holding the injector levers—do not exert unnecessary
pressure on the faceplate.
Hot swap compliant modules may be installed while the system is powered
on. If a module is not hot swap compliant, you should remove power to the
slot or system before installing the module. See
for more information.
Refer to the following illustration and perform these steps when installing
modules. Note that this illustration is for general reference only and may
not accurately depict the connectors and handles on the board you are
installing.
