Installing Memory Modules, PMCs, and Drives
http://www.motorola.com/computer/literature
1-11
1
Mounting PCI Mezzanine Cards
You can mount one or two +5V and/or Universal PCI Mezzanine Cards
(PMCs) on the CPN5365. Each PMC site is keyed for +5V PCI bus
interface.
!
Caution
Inserting or removing PMCs with power applied may result in damage to
module components.
Note
You cannot install PMC cards that are only compatible with
+3.3V PCI.
The upper PMC module I/O (PMC 2) connects to J3 and the lower PMC
module I/O (PMC 1) connects to J5. Signal routing for PMC I/O must be
about one inch to permit use of different types of high speed devices. If you
mount the on-card hard drive you cannot use the upper PMC site (PMC 2).
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. Keep the ESD secured throughout
this procedure.
2. Shut down the operating system.
3. Turn AC or DC power off and remove the AC cord or DC power
lines from the system.
4. Remove chassis or system cover(s) as necessary.
5. Carefully remove the CPN5365 from its card slot and lay it flat, with
connectors J1 through J5 facing you.
6. Remove the PMC filler from the front panel.
!
Caution
Do not damage or bend connector pins.
7. Slide the edge connector of the PMC module into the front panel
opening from behind and place the PMC module on top of the base
board. Align the four connectors on the underside of the PMC
module with the corresponding connectors on the CPN5365:
