Pr
og
ramming F
eatur
es
30
3. Turn on the target radio and place it directly behind the source
radio in the MUC.
4. Press and hold
Q
on the source radio. The source radio enters
Cloning Mode and transmits its settings to the target radio. Either
W
for pass or
N
for fail appears on the source radio and the target
radio displays all icons if cloning was successful.
5. Turn the target radio off and back on again to use.
6. To clone additional radios, repeat steps 3 and 5.
7. Exit
k
on the source radio by holding down
M
.
Note: You can clone only one radio at a time.
The MUC does not need to be plugged in for Cloning feature to work.
Radios must be of the same band; UHF or VHF. Also, multi-channel models
can clone to single-channel radios, but only the first channel is cloned.
Target radio
k
218
188
Source radio
operation.fm Page 30 Thursday, June 5, 2003 2:25 PM
Summary of Contents for CP100
