Motorola DCH6200, Operation Manual

ii

V E N T I L A T E

2

inch space

2

inch

2

inch

DCH6200

During Installation 

•

Do not place the cable terminal in an enclosed area where the cooling vents are blocked or impede 
the flow of air through the ventilation openings. 

•

Install the terminal so that its position does not interfere with its proper ventilation. For example, 
do not place the terminal on a bed, sofa, rug, or similar surface that could block the ventilation 
openings. 

•

Install the terminal away from heat sources such as radiators, heat registers and stoves. 
Installation of the terminal near consumer electronics devices, such as stereo receiver/amplifiers 
and televisions, is permitted as long as the air surrounding the terminal does not exceed 40º C 
(104º F). 

•

Place the terminal on a flat surface not prone to vibration or impact. 

•

Do not install the terminal in an area where condensation occurs. 

•

To prevent the temporary loss of guide data and cause a temporarily non-responding terminal, do 
not plug the AC power cord into a switched power outlet. 

FCC COMPLIANCE 

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates uses and can radiate 
radio frequency energy and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no guarantee that interference will 
not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following measures: 

•

Reorient or relocate the receiving antenna. 

•

Increase the separation between the equipment and receiver. 

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 

•

Consult the dealer or an experienced radio/TV technician for help. 

Caution:

 Changes or modifications not expressly approved by Motorola for compliance could void the 

user’s authority to operate the equipment. 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired operation.