Motorola DCH70, User Manual

iii

During Installation 

•

Do not place the cable terminal in an enclosed area where the 
cooling vents are blocked or impede the flow of air through the 
ventilation openings. 

•

Install the terminal so that its position does not interfere with its 
proper ventilation. For example, do not place the terminal on a bed, 
sofa, rug, or similar surface that could block the ventilation 
openings. 

•

Install the terminal away from heat sources such as radiators, heat 
registers, and stoves. Installation of the terminal near consumer 
electronics devices, such as stereo receiver/amplifiers and 
televisions, is permitted as long as the air surrounding the terminal 
does not exceed 40 ºC (104 ºF). 

•

Place the terminal on a flat surface not prone to vibration or impact. 

•

Do not install the terminal in an area where condensation occurs. 

•

To prevent the temporary loss of guide data and cause a 
temporarily non-responding terminal, do not plug the AC power 
cord into a switched power outlet. 

FCC COMPLIANCE 

Note: This equipment has been tested and found to comply with the 
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment 
generates, uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and 
on, the user is encouraged to try to correct the interference by one or 
more of the following measures: