Diagnostics D-9
DCP501 Installation Manual
The DCP501 can receive only six PIDs at one time. Data on PIDs can be present on the
out-of-band multiplex that the DCP501 is not receiving.
Operator Selection of the OOB Frequency
1
When in the OOB Receiver Status Diagnostic, press the
MENU
button to enter the frequency
selection mode. The frequency of the last known carrier is displayed on the LEDs. The
on
-
screen display displays a new MANUAL FREQ line at the bottom of the screen, which
indicates the last known carrier frequency. At this point, if desired, the operator can exit the
frequency change mode by pressing the
MENU
button a second time.
2
The operator can use the
UP
/
DOWN
channel or cursor buttons to scroll through all 10
frequencies until the desired new OOB frequency is found. The new frequency selections will
appear on the LEDs and on the MANUAL FREQ line of the on
-
screen display. When the last
known frequency is selected, a DOT will appear in the middle
-
upper part of the LEDs.
3
When the desired new frequency has been selected, the operator will press the
SELECT
button to start the search (As the DCP501 searches for a frequency, the LEDs will flash.) On
the on
-
screen display, the MANUAL FREQ line of text will be cleared, the HUNT MODE
will display FIX to indicate a search on a fixed frequency, and the CUR FREQ field will
change to the frequency being searched for.
4
If the frequency is found with the proper EMM Provider ID, the LEDs will display the
normal OOB receiver status as shown in Figure D-4. The OSD LKC field will change to
display the new frequency.
5
If after 40 seconds the frequency search is not successful, the DCP501 will perform a warm
reset.
6
If you want to abort a search without waiting the 40 seconds, press
POWER
to cause an
immediate warm reset.
Summary of Contents for DCP501 - DVD Player / AV Receiver
Page 188: ...486724 001 09 02 MGBI ...
