3333 ---- 1 8
1 8
1 8
1 8
I n s t a l l a t i o n
D C T 2 0 0 0 I n s t a l l a t i o n M a n u a l
O p e r a t i o n a l C h e c k
The operational check tests the communication link between the remote control and the
DCT 2000. The procedures verify the DCT 2000 response to remote control commands.
Table 3-2 lists the operational check procedures:
T a b l e 3 - 2
O p e r a t i o n a l c h e c k
F e a t u r e
T e s t i n g P r o c e d u r e
Power on
§
Press
POWER
to turn on the DCT 2000.
§
Turn on the TV and tune it to the output channel of the DCT 2000 (channel 3 or 4).
Channel Selection
§
Scan through the channels using the
CHANNEL
keys on the DCT 2000 and the
CHANNEL
+ -
keys on the remote control.
§
Tune to several channels by entering the channel number with the numeric keys on the remote
control.
Volume Control
§
Use the TV volume control to adjust the sound volume to a moderate level.
§
Press
VOLUME
+ - on the remote control to increase the volume to its upper limit, lowest level, and
to a comfortable level.
§
Press
MUTE
to turn the sound completely off. Press
MUTE
again to restore the sound.
If the DCT 2000 does not operate properly, refer to Section 5, “Troubleshooting.”
Summary of Contents for DCT2000
Page 70: ...02 00 469714 001 99 ...
