•
IP address — Displays the IP address of the device when connecting to Wi-Fi networks.
8.2.6
WLAN Configuration
Use the WLAN Configuration settings to configure additional WLAN settings.
From the Wi-Fi screen, tap
→
Advanced to view the settings. The following two settings are used to
configure WLAN:
•
Wi-Fi frequency band
-
Auto (2.4GHz and 5GHz) —Use both the 2.4 GHz and 5 GHz bands (default).
-
5GHz Only — Use only the 5 GHz band.
-
2.4GHz Only —Use only the 2.4 GHz band.
•
Keep Wi-Fi on during sleep
-
Always — Wi-Fi is always enabled even in sleep mold.
-
Only when plugged in — Wi-Fi is enabled only when the device is plugged in. If the device is
not plugged in, the device will not enter the sleep mold.
-
Never (increases data usage) — Wi-Fi is never disabled.
8.2.7
Modifying a Wi-Fi Network
The user can change settings and passwords for a network in the Wi-Fi list.
When and where to use: Use this procedure to modify a Wi-Fi network.
Procedure:
1 Tap
.
2 Tap
.
3 Tap
Wi-Fi.
4 Slide the Wi-Fi switch to the ON position.
5 Tap and hold on a network name and then tap Modify network.
6 Modify the network settings and then tap Save.
7 Tap
.
8.2.8
Removing a Wi-Fi Network
When and where to use: Use this procedure to remove a Wi-Fi network from your list of Wi-Fi
networks.
Procedure:
1 Tap
.
2 Tap
.
3 Tap
Wi-Fi.
MN002858A01-A
Chapter 8: Wireless
141
Summary of Contents for LEX L10g
