•
Personal Area Network (PAN) — Allow the use of Bluetooth Network Encapsulation Protocol on
Layer 3 protocols for transport over a Bluetooth link.
•
General Audio/Video Distribution Profile (GAVDP) — Provides the basis for A2DP, and VDP.
•
Phone Book Access Profile (PBAP) — Allows exchange of Phone Book Objects between a car kit
and a mobile phone to allow the car kit to display the name of the incoming caller; allow the car kit
to download the phone book so the user can initiate a call from the car display.
•
Message Access Profile (MAP) — allows exchange of messages between devices.
•
Headset Profile (HSP) — Provides support for the popular Bluetooth headsets to be used with
mobile phones with ability to ring, answer a call, hang up and adjust the volume.
•
File Transfer Profile (FTP) — Provides the capability to browse, manipulate and transfer files and
folders in a file system of another system.
•
Proximity profile (PXP) — Enables proximity monitoring between two devices.
•
Heart Rate Profile (HRP) — Enables transmission and reception of medical device data.
•
Health Thermometer profile (HTP) — Enables transmission and reception of medical device data.
8.3.4
Bluetooth Power States
The Bluetooth radio is off by default.
The following modes are available:
•
Suspend — When the device goes into suspend mode, the Bluetooth radio stays on.
•
Airplane Mode — When the device is placed in Airplane Mode, the Bluetooth radio turns off.
When Airplane Mode is disabled, the Bluetooth radio returns to the prior state. When in Airplane
Mode, the Bluetooth radio can be turned back on if desired.
8.3.5
Bluetooth Radio Power for Android
Turn off the Bluetooth radio to save power or if entering an area with radio restrictions (e.g., an
airplane). When the radio is off, other Bluetooth devices cannot see or connect to the device. Turn on
the Bluetooth radio to exchange information with other Bluetooth devices (within range). Communicate
only with Bluetooth radios in close proximity.
NOTICE: To achieve the best battery life, turn off radios when not in use.
8.3.5.1
Enabling Bluetooth
When and where to use: Use this procedure to enable Bluetooth.
Procedure:
1 Tap
.
2 Tap
.
3 Slide the Bluetooth switch to the ON position.
also appears in the Status bar.
4 Tap
.
MN002858A01-A
Chapter 8: Wireless
144
Summary of Contents for LEX L10g
