2-1
2
2
Operating Instructions
Introduction
This chapter provides information applicable to the MCP750HA family of
Single Board Computers in a system configuration. This includes the
power-up procedure along with descriptions of the switches and LEDs,
memory maps, and software initialization.
Applying Power
After you have verified that all the necessary hardware preparation has
been done (with all connections made correctly) and that the installation is
complete, you can power up the system. The MPU, hardware, and
firmware initialization process is performed by the PowerPC™ PPCBug
power-up or system reset. The firmware initializes the devices on the SBC
module in preparation for booting the operating system.
The firmware is shipped from the factory with an appropriate set of
defaults. In most cases there is no need to modify the firmware
configuration before you boot the operating system.
shows the basic initialization process that takes place during
PowerPC system startup.
When using the MCP750HA in a hot swap capable chassis, the module
may be inserted and extracted with power applied.
For additional information on PPCBug, refer to
, and
Chapter 6, CNFG and ENV Commands
, to the PPCBug Firmware
Package User’s Manual, and to the CPX750 High Availability PPCBug
Firmware User’s Manual. Both manuals are listed in
Summary of Contents for MCP750HA Series
Page 161: ......
