MEVB SUPPORT INFORMATION
4-6
M68MPB16R3UM/D
Table 4-6. Logic Analyzer Connector J12 Pin Assignments (continued)
Pin
Mnemonic
Signal
17
SIZ0
TRANSFER SIZE – Output signal that indicate the
number of bytes still to be transferred during this
cycle.
18
R/W
READ/WRITE – Output signal that indicates the
direction of data transfer on the bus.
19
BGACK /
CSE
BUS GRANT ACKNOWLEDGE – Active-low input
signal that indicates an external device has assumed
bus mastership.
EMULATOR CHIP SELECT – Output signal that
selects external emulation devices at internally-
mapped addresses. CSE is used to emulate I/O
ports.
20
GND
GROUND
Table 4-7. Logic Analyzer Connector J13 Pin Assignments
Pin
Mnemonic
Signal
1
+5V
+5 VDC POWER – Input voltage (+5Vdc @ 1.0 A)
used by the MEVB logic circuits. (To make this pin a
no connection, remove the jumper from jumper
header W21 on the MPFB.)
2
SPARE
No connection
3
DSACK1
DATA AND SIZE ACKNOWLEDGE 1 – Active-low
input signal that allows asynchronous data transfers
and dynamic bus sizing between the MCU and
external devices.
4
AVEC
AUTOVECTOR – Active-low input signal that
requests an automatic vector during interrupt
acknowledge.
5
HALT
HALT – Active-low input/output signal that suspends
external bus activity, to request a retry when used
with BERR, or for single-step operation.
6
AS
ADDRESS STROBE – Active-low output signal that
indicates a valid address is on the address bus.
