23
Using the T
elephone
24
Using the T
elephone
Press the
key to switch the microphone on
or off during a call.
Muting the Microphone
1.
If the telephone is connected to a switchboard network, it is possible to put calls on
hold and call other extensions or to forward calls.
Press the key to put the call on hold.
Dial the number of the extension (e.g. 23).
Press the key once more to take the call
back again or the key to forward the call.
Holding and Forwarding Calls
1.
2.
3.
Note: The above information can vary according to the PBX network used. Therefore,
refer to the relevant information in the PBX/switchboard user guide.
1.
2.
4.
Press the
key and enter the number of the
corresponding handset (e.g. 2) which should be included in the call.
The external caller is kept on hold. As soon as handset 2 takes the call, press
key to transfer the call to handset 2.
Or
By pressing the key, any of the handsets can be disconnected from the
teleconference and the other handset continues with the external call.
If you are already on an external call, you can include another
internal handset in the conversation and hold a three-way
conference call. Or you can simply transfer the caller to the
other handset.
Teleconference and Call Transfer
Entering a Dialing Pause (P)
If your Motorola ME4067 is connected to a switchboard/PBX it may be necessary to
enter a dialling pause in order to give the switchboard time to get an outside line
before dialling the number. To do this, press the key after entering the
relevant digit, e.g. 0, for an outside line (0P....). A 'P' appears in the display indicating
a pause. The pause can also be entered when programming numbers in the phone
book.
3. The external caller is kept on hold. As soon as handset 2 takes the call, press
and hold key to begin the conference call.
During a call you can mute the microphone so your caller cannot hear you while you
speak privately to someone else in the room. The icon is displayed when the
microphone is muted.
