7
English
OPERATING INSTRUCTIONS
Amplifier Chargers are intended for use only with the authorized Motorola batteries and power
supplies listed in Table 1 and Table 2; usage with unauthorized products may prevent proper
operation and may damage the device.
The battery charger will accommodate a pager with an attached battery in the front pocket, and a battery
alone in the rear pocket. To charge a battery, use the following procedure:
1.
Plug the round end of the power supply cord into the DC Connector on the back of the charger.
2.
Plug the power supply into the appropriate AC outlet. The spare battery LED and pager battery LED will
flash single green once and the alert LED will flash single red once to indicate a successful power-up.
3.
Insert a pager with battery into the charger's front pocket by:
a.
aligning the groove on each side of the pager with the corresponding raised rail on each side of the
charger pocket.
b.
sliding the pager into the charger pocket, ensuring complete contact between the charger and pager
contacts.
4.
When the pager is properly seated in the pocket, the charger LED will light in accordance with Table 5 on
page 10.
Note:
•
Charge new batteries overnight to ensure full charge. To minimize charge time, it is recommended to turn
the pager OFF.
•
The Amplifier Charger is not designed to accommodate the alkaline battery tray.
•
During receipt of a page, the LED may flash amber, indicating charging has temporarily been suspended.
68012010008_b.book Page 7 Tuesday, May 6, 2014 2:07 PM
