Motorola MT060, Owner'S Manual

•

8

•

USING THE LIGHT

There are 5 lighting modes:

• High (100% power)

• Normal (50% power)

• Energy saving (25% power)

• Emergency flash

• SOS

Press once to turn the light ON or OFF. 

Press twice quickly, to change to the  

next mode.

USING THE AC POWER OUTLETS

The MT060 is equipped with a 500W pure 

sine wave inverter, which produces the 

best power for all electronic devices and 

appliances, without damage.

It is important to know the continuous 

wattage of the device you plan to use with 

the AC outlets. The unit must be used with 

devices drawing 500 watts or less. 

Devices such as fans or electric 

motors require additional power to start 

(commonly known as the “starting” or 

“peak” power). The generator can supply 

a momentary surge in wattage of as high 

as 2,500W for less than 1/10 of a second; 

however even devices rated less than 

the maximum 500 watts can exceed the 

inverter’s surge capability and cause an 

automatic overload shutdown.

Do not use the inverter with a product that 

draws a higher wattage than the inverter 

can provide, as this may cause erratic 

operation.

CAUTION:

 Always run a test to establish 

whether the inverter will operate a 

particular piece of equipment or device.

In the event of a power overload (noted 

with an audible alarm beeping every 3 

seconds and a flashing   Warning icon), 

the inverter is designed to automatically 

shut down. This safety feature prevents 

damaging the inverter while testing devices 

and equipment within the 500-watt range.

If powering more than one device, start one 

device at a time to avoid a power surge and/

or inverter overload. The surge load of each 

device should not exceed the inverter’s 

Continuous Operation wattage rate.

You can use an extension cord from the 

inverter to the device without significantly 

decreasing the power being generated by 

the inverter. For best operating results, the  

extension cord should be 16 AWG (1.31 mm

2

)  

or larger and no longer than 50 feet.

WARNING! RISK OF ELECTRIC SHOCK.

Incorrect operation of your inverter may 

result in damage and personal injury. The 

inverter output is 110V AC and can shock 

or electrocute the same as any ordinary 

household AC wall outlet.

NOTE:

 The maximum continuous load  

is 500 watts. Do not use the AC outlets with 

a product that draws more than 500 watts, 

as this may cause erratic operation. 

CAUTION:

• Do not connect an AC power source to 

the 110V AC outlets.

• Do not connect the unit’s AC power cord 

to its 110V AC outlets.

NOTE:

 Do not power an AC device while 

charging the internal battery. 

1. 

Connect your AC-powered devices or 

small household appliances to one or 

more of the unit’s two AC outlets. 

NOTE: 

Make sure the device to be 

powered is OFF before inserting the plug 

into the AC power outlet.

2. 

Press the AC Output button. The 

 AC Output icon will show on the 

display and the green AC power LED 

lights, to confirm that the unit is on and 

ready to provide AC power. The rotating 

 Discharging indicator will also show 

on the display.

NOTE: 

Extended operation of an AC device 

may result in excessive battery drain. 

3. 

Recharge the unit when the battery 

level is below 40%.

ESTIMATED RUN-TIMES 

APPLIANCE TYPE

ESTIMATED 

RUN TIME

CHARGES

Projector

8 hours

—

12V Heated blanket

15 hours

—

12V Cooler

17 hours

—

Mini refrigerator

23 hours

Drone

24 hours

145

Television

24 hours

—

Fan

29 hours

—

Router

60 hours

—

Table lamp

65 hours

—

Laptop

117 hours

17

LED lights

167 hours

—

Go Pro

210 hours

140

Radio

245 hours

—

Tablet

273 hours

22

Speaker

750 hours

63

Smartphone

843 hours

70

NOTE:

 Actual time may vary. Times are based  

on the internal battery being fully charged.