68P02963C70-O
iii
• Australian Communications Authority Radiocom-
munications (Electromagnetic Radiation –
Human Exposure) Standard 1999 (applicable to
wireless phones only)
• Anatel, Brasil Regulatory Authority
“This equipment is in compliance with the limits
of Specific Absorption Rate which refer to the
exposal to electric, magnetic and electromagnetic
fields adopted by ANATEL.”
To assure optimal handset performance and make sure
human exposure to radio frequency electromagnetic
energy is within the guidelines set forth in the above
standards, always adhere to the following procedures:
Phone Operation
When placing or receiving a phone call, hold your handset
as you would a wireline telephone.
Speak directly into
the microphone.
Two-way radio Operation
When using your handset,
hold the handset in a vertical
position with the microphone 2.5 to 5 cm away from
your mouth.
Body-worn Operation
To maintain compliance with these RF exposure
guidelines, if you wear a handset on your body when
transmitting, always place the handset in
a Motorola
approved belt clip or leather case for this product.
Use
of non-Motorola-approved accessories may exceed these
RF exposure guidelines.
If you do not use a Motorola
approved body-worn accessory and are not using the
handset in the intended use positions along side of the
head in the phone mode or in front of the face in the
two-way radio mode, then ensure the antenna and
handset is kept the following minimum distances from
the body when transmitting:
•
Phone or Two-way radio mode: 2.5 cm
•
Data operation using any data feature with or
without an accessory cable: 2.5 cm
Antenna Care
Use only the supplied or an approved replacement
antenna.
Unauthorized antennas, modifications, or
attachments could damage the handset and may violate
FCC regulations.
DO NOT hold the antenna when the radio is “IN
USE”.
Holding the antenna affects call quality and may
cause the radio to operate at a higher power level than
needed.
Approved Accessories
For a list of Approved Motorola accessories, please see
“REPLACEMENT PARTS AND KITS” on page 45.
Electromagnetic Interference/Compatibility
NOTE:
Nearly every electronic device is susceptible to
electromagnetic interference (EMI) if inadequately
shielded, designed or otherwise configured for
electromagnetic compatibility.
Facilities
To avoid electromagnetic interference and/or
compatibility conflicts, turn off your handset in any
facility where posted notices instruct you to do so.
Hospitals or health care facilities may be using
equipment that is sensitive to external RF energy.
Aircraft
When instructed to do so, turn off your handset when on
board an aircraft. Any use of a handset must be in
accordance with applicable regulations per airline crew
instructions.
Medical Devices
Pacemakers
The Health Industry Manufacturers Association
recommends that a minimum separation of 15
centimetres be maintained between a handheld wireless
handset and a pacemaker. These recommendations are
consistent with those of the U.S Food and Drug
Administration.
Persons with pacemakers should:
• ALWAYS
keep the handset more than 15 centi-
metres from their pacemaker when the handset is
turned ON.
• not carry the handset in the breast pocket.
• use the ear opposite the pacemaker to minimise
the potential for interference.
• turn the handset OFF immediately if you have
any reason to suspect that interference is taking
place.
Hearing Aids
Some digital wireless handsets may interfere with some
hearing aids. In the event of such interference, you may
want to consult your hearing aid manufacturer to discuss
alternatives.
Other Medical Devices
If you use any other personal medical device, consult the
manufacturer of your device to determine if it is
adequately shielded from RF energy. Your physician
may be able to assist you in obtaining this information.
Summary of Contents for MTH500
