• Emergency Mode
• Silent Emergency Mode
• Covert Mode
Send firmware version and TEI
The radio sends back an SDS message with its firmware version and TEI.
NOTICE:
If the sending Individual Short Subscriber Identity (ISSI) is not on the Allowed ISSIs
list, the receiving radio ignores the task.
4.7.7.2
SDS Remote Control
NOTICE:
This is a Software Selling Feature. Only one type of remote control can be active on a
radio; either SDS or Status.
SDS Remote Control is a feature that enables remote control and configuration of the radio using
special SDS messages. The messages can be sent both in TMO and DMO (including the Repeater
Mode) by any radio capable of controlling other radios. During the execution of the Remote Control
messages, depending on your service provider settings, the radio can play a tone or display an
appropriate icon in the status icon area.
4.7.7.3
Setting Remote Control
This procedure describes how to toggle remote control.
Procedure:
1
From the home screen, press the
Menu
key.
2
Select
Security
→
Remote Control
.
3
Select
On
to enable, or
Off
to disable remote control.
4.8
Setup
The Setup menu allows you to change the general configuration on your radio.
4.8.1
Ring Style
This sub-menu allows you to set the incoming call ring style.
4.8.1.1
Setting Ring Style
Procedure:
1
From the home screen, press the
Menu
key.
2
Select
Setup
→
Ring Style
.
3
Select one of the following options:
•
Duplex
– To set the new ring style to all duplex calls.
•
Simplex
– To set the new ring style to all simplex calls.
68015000899-FH
Chapter 4: Main Menu
93
