PCI Expansion Connector
Power Requirements
(not including power required by PMC or IMPC modules)
Board Size
I P M C M o d u l e s
PMC Interface
SCSI Bus
Synchronous Serial Ports
Asynchronous Serial Ports
Parallel Port
Power Requirements
(additional power load placed on MVME5100 with IPMC installed)
T r a n s i t i o n M o d u l e s
I/O Connectors
Board Size
A l l M o d u l e s
Environmental
(Minimum of 400 LFM (linear feet per minute) of forced air cooling is
recommended for operation in the higher temperature ranges.)
Address/Data:
A32/D32/D64
PCI Bus Clock:
33 MHz
Signaling:
5V
Connector:
114-pin connector located on the planar
of the MVME5100
+5V
±
5%
+12V
±
10%
–12V
±
10%
MVME5100:
3.0 A typ.
8.0 mA typ.
2.0 mA typ.
MVME5100 with
MVME761:
3.2 A typ.,
4.0 A max.
0.2 A typ.
0.5 A max.
0.1 A typ.
0.3 A max.
Height:
233.4 mm (9.2 in.)
Depth:
160.0 mm (6.3 in.)
Front Panel Height:
261.8 mm (10.3 in.)
Width:
19.8 mm (0.8 in.)
Max. Component
Height:
14.8 mm (0.58 in.)
Address/Data:
A32/D32/D64, PMC PN1, PN2, PN3,
PN4 connectors
PCI Bus Clock:
33 MHz
Signaling:
5V
Module Type:
Basic, single-wide; P2 I/O
Controller:
Symbios 53C895A
PCI Local Bus DMA:
Yes, with PCI local bus burst
Asynchronous (8-bit
mode):
5.0MB/s
Ultra SCSI:
20.0MB/s (8-bit mode), 40.0MB/s (16-bit
mode)
Note: 16-bit SCSI operation precludes the use of some PMC Slot 2
signals.
Controller:
85230/8536
Number of Ports:
Two (IPMC761); one (IPMC712)
Configuration:
IPMC761: TTL to P2 (both ports), SIM
configurable on MVME761;
IPMC712: EIA-232 to P2
Baud Rate, bps max.:
2.5M sync, 38.4K async
Oscillator Clock Rate
(PCLK):
10 MHz/5 MHz
Controller:
16C550 UART; 85230/8536
Number of Ports:
Two (IPMC761); three (IPMC712)
Configuration:
EIA-574 DTE (IPMC761);
EIA-232 (IPMC712)
Async Baud Rate, bps
max.:
38.4K EIA-232, 115Kbps raw
IPMC Modules
Controller:
PC97307
Configuration:
8-bit bi-directional, full IEEE 1284 sup-
port; Centronics compatible (minus EPP
and ECP on MVME712M)
Modes:
Master only
IPMC761
IPMC712
+5V:
0.5 A max.
0.5 A max.
+3.3V
0.75 A max.
0.75 A max.
MVME761
MVME712M
Asynchronous
Serial Ports:
Two, DB-9 labeled as
COM1 and COM2
Three, DB-25 labeled
as Serial 1, Serial 2,
and Serial 3
Synchronous
Serial Ports:
Two HD-26 labeled as
Serial 3 and Serial 4
(user configurable via
installation of SIMs),
Two 60-pin connectors
on MVME761 planar
for installation of two
SIMs
One, DB-25 labeled as
Serial 4
Parallel Port:
HD-36, Centronics
compatible
D-36, Centronics com-
patible
Ethernet:
10BaseT or
100BaseTX, RJ-45
not available
SCSI:
8- or 16-bit, 50- or 68-
pin connector via P2
adapter
8-bit, standard SCSI D-
50
Height:
233.4 mm (9.2 in.)
Depth:
80.0 mm (3.1 in.)
Front Panel Height:
261.8 mm (10.3 in.)
Front Panel Width:
MVME761: 19.8 mm (0.8 in.)
MVME712M: 39.6 mm (1.6 in.)
Operating
Nonoperating
Temperature:
0° C to +55° C
(inlet air temp. w/forced
air cooling)
–40° C to +85° C
Humidity (NC):
5% to 90%
5% to 90%
Vibration:
2 Gs RMS,
20–2000 Hz random
6 Gs RMS,
20–2000 Hz random
Transition Modules
All Modules
