Internet Key Exchange for VPNs 6-9
•
Include Vendor-ID Payload
toggles whether or not the Router includes the vendor-ID payload in its IKE
Phase 1 messages.
•
Independent Phase 2 Re-keys
toggles whether or not a Phase 2 re-keys requires a Phase 1 re-key. If this
item is set to Yes (the default), Phase 2 re-keys will be per formed independently when necessar y without
requiring a Phase 1 re-key. If this item is set to No, each Phase 2 re-key will be preceded by a Phase 1
re-key. This item should normally be set to Yes unless the device is communicating with a non-compliant
remote IPsec peer that requires that a Phase 1 re-key precede each Phase 2 re-key.
•
Strict Port Policy
toggles whether or not IKE requires packets to originate from the IANA IKE por t (500).
Set to
Yes
, the Router will listen only to por t 500 and source its packets from por t 500. Set to
No
, the
Router will return traffic to whatever por t originated it.
•
Invalid SPI recovery
Toggling this option to
Yes
allows the Router to re-establish the tunnel if either the Netopia Router or the
peer gateway is rebooted.
If an IPSec packet that does not have a valid SPI is received from the peer address, a new Phase 1
negotiation is initiated to the peer in order to securely transmit an invalid-SPI message. This will cause a
renegotiation of new IPSec SAs.
•
Traffic based Dead Peer Detection
The default is
No
. Toggling this option to
Yes
allows IKE to negotiate RFC3706-based IKE “keepalives” with
a remote security gateway (IKE peer) that suppor ts them.
If this feature is enabled and negotiated with its peer, keepalive messages are sent when:
•
the IPSec link has not received anything in
DPD Keepalive Idle Time
seconds (see below),
and
•
some IPSec traffic is sent,
and
•
one second passes with no IPSec traffic having been received.
If the IKE peer suppor ts the keepalives, the tunnel will reset to allow for reestablishment when the peer
does not respond to the keepalive.
This permits the router to maintain its IPSec session without the requirement of constant keep alive traffic.
Determination of peer liveliness is only needed during idle periods, since tunneled traffic is itself evidence
of liveliness. Once enabled and negotiated, all tunnels established by the IKE phase 1 instance when the
peer no longer responds to IKE keepalive messages will be killed.
When you enable this option, the next option, DPD Keepalive Idle Time (seconds), appears.
•
DPD Keepalive Idle Time (seconds)
allows you to specify an inter val, from 3 to 65535 seconds, during
which IPSec traffic may be idle before the router sends a keepalive message to its peer. The default is 20
seconds.
Changing an IKE Phase 1 Profile
To make changes to an IKE Phase 1 Profile, select
IKE Phase 1 Configuration
from the WAN Configuration
menu, and press Return.
Summary of Contents for Netopia Embedded Software
