7-8 Administrator’s Handbook
•
To install the static route in the IP routing table, select
Static Route Enabled
and toggle it to
Yes
. To
remove the static route from the IP routing table, select
Static Route Enabled
and toggle it to
No
.
•
Be sure to read the rules on the installation of static routes in the IP routing table. See
“Rules of static
route installation” on page 7-9
.
•
Select
Destination Network IP Address
and enter the network IP address of the destination network.
•
Select
Destination Network Subnet Mask
and enter the subnet mask used by the destination network.
•
Select
Next Gateway IP Address
and enter the IP address for the gateway that the Router will use to reach
the destination network. This gateway does not necessarily have to be par t of the destination network, but
it must at least know where to for ward packets destined for that network.
•
Select
Route Priority
and choose
High
or
Low
. High means that the static route takes precedence over RIP
information; Low means that the RIP information takes precedence over the static route.
•
If the static route conflicts with a connection profile, the connection profile will always take precedence.
•
To make sure that the static route is known only to the Router, select
Advertise Route Via RIP
and toggle
it to
No
. To allow other RIP-capable gateways to know about the static route, select
Advertise Route Via
RIP
and toggle it to
Yes
. When Adver tise Route Via RIP is toggled to
Yes
, a new item called
RIP Metric
appears below
Advertise Route Via RIP
.
With RIP Metric you set the number of gateways, from 1 to 15, between the sending gateway and the
destination gateway. The maximum number of gateways on a packet’s route is 15. Setting
RIP Metric
to
1
means that a route can involve 15 gateways, while setting it to
15
means a route can only involve one
gateway.
•
Select
ADD STATIC ROUTE NOW
to save the new static route, or select
CANCEL
to discard it and return to
the Static Routes screen.
Add Static Route
Static Route Enabled: Yes
Destination Network IP Address: 0.0.0.0
Destination Network Subnet Mask: 0.0.0.0
Next Gateway IP Address: 0.0.0.0
Route Priority... High
Advertise Route Via RIP: No
ADD STATIC ROUTE NOW CANCEL
Configure a new Static Route in this Screen.
Summary of Contents for Netopia Embedded Software
