2
Display radios will show
CLONE
(source
radio) and
PROGRAM
(target radio).
4. Release both side buttons of source radio.
The electronic transfer begins and will take
less than one minute. When cloning is
completed, the source radio produces a
“clone-exit” tone and displays
DONE
. Both
radios reset themselves and turn off their
green LEDs.
5. Turn off source and target radio; then dis-
connect cloning cable from each radio.
6. Turn on source and target radio for normal
operation.
ERROR CODES (Display Radios Only):
•
ERR 01
— The model numbers or the code
plug versions are not the same for both
radios. Cloning cannot be performed.
•
ERR 02
— Communication between the two
radios was not established or was dis-
rupted during the cloning procedure. If this
occurs, check the cloning cable and all
connections. Repeat the cloning proce-
dure.
92C95-A_Text_EN.fm Page 2 Tuesday, January 27, 2004 3:06 PM
